Hello to everyone,for my graphical application I usually use custom boards with STM32H750XB mcu.For all my projects I always used STMCube IDE 1.6.1.Code is executed from external qspi flash, so I create a bootloader to launch the application and debu...

I've used Nucleo-F303RE + STEVAL-IPM05F to profile my 8pole 3ph brushless motor. Then, I've used motor control workbench to setup EVSPIN32F0602S1 with my motor. The motor work very fine, but at maximum speed of 1300rpm (0.7A on each motor phase) mos...

Hi,I'm trying to convert a project generated with GFX for F7, to H7, and also integrate it to one cubeMX generated project for atollic.I'm at the point in which, app run (i think correctly,no hard fault), but I can't see any transfer to display fram...

I'm a newbie in motor control. I'm working on STSPIN32F0A for control a 24V BLDC motor.It was very simple configure e control the motor at different speed (2900 to 3400 rpm) with no load. I've got only some measure(rpm / phase current / torque / powe...