About RAnge.1

RAnge.1 · 2021-03-26

I am using the H730, with the USB High Speed enabled on my own PCB setup. On some occasions, the USB will work as expected. However, most of of the time, it would enter the Error_Handler Loop. I used the CUBEIDE and ioc gui to enable the usb hsThe tr...

RAnge.1 · 2021-01-29

I'm trying to generate a signal from DAC3 (connected only to internal peripherals) from my G473 and output that value through OPAMP1 in follower mode. The output of the pin of the OPAMP is stuck at low forever however. I set the DAC from CUBEIDE as s...

User statistics

User Activity

USB HS on H730 is temperamental, constant error_handler()

STM32G473 DAC3 to OPAMP output stuck at low.