About Entony

Entony · 2025-03-06

We are using the STM32WL55CCU6 processor and generating code for two cores. For GPIO it is not possible to specify which core will initialize the GPIO (of course, it is not necessary) but the code and definitions are not generated for any core.STM32C...

Entony · 2021-12-16

10:55:25 : ST-LINK SN : 0034003E3137510339383538 10:55:25 : ST-LINK FW : V3J8M3B5S1 10:55:25 : Board : STLINK-V3MODS 10:55:25 : Voltage : 3.29V 10:55:25 : SWD freq : 8000 KHz 10:55:25 : Connect mode: Under Reset 10:55:25 : Reset mode : Softwar...

Entony · 2024-05-01

Hello and thank you for your reply. It was my mistake, I was using an old version of the app. (st25nfcApplication_V3.7.0).Everything is okay now.

Entony · 2024-04-16

Hi Oliver,thank you for your answer. You are right, it was a problem with the AndroidReaderInterface AAR file, I had an older version 1.0.8

Entony · 2024-04-16

Hi Oliver,We have same problem on Android 13... Can you help me please with this error: cannot find symbolandroidReaderInterface.setAndroidTag(newAndroidTag); setAndroidTag is not defined in AndroidReaderInterface class??

Entony · 2021-12-16

We had an old version, v2.8.0. Now we have a new version v2.9.0 and it works fine!Thanks for the warning and I'm sorry, that should have occurred to me.;)

User statistics

User Activity

STM32CubeIDE not generate code for GPIO pin

We have a problem downloading to the STM32L100 processor. It was programmed using STLink. Now we want to use STM32CubeProgrammer. Writing is not possible! It is not possible to change the RDP value either. If we use STLink, all is OK.

Re: ST25 NFC Tap app issue on Android Version 14

Re: ST25NFCApplicationV3.7.0 Crashes on Android 13 (Pixel6a)

Re: ST25NFCApplicationV3.7.0 Crashes on Android 13 (Pixel6a)

Re: We have a problem downloading to the STM32L100 processor. It was programmed using STLink. Now we want to use STM32CubeProgrammer. Writing is not possible! It is not possible to change the RDP value either. If we use STLink, all is OK.