Hi,iam trying to get a full understanding of remoteproc and its resource tabel. In the paper i read i understood it that the resource table is used to give the information about the vrings location to the master and the slave. The master parses the ...

Hi,i have done some Benchmarktest via Rpmsg and iam getting following results:Maximal datarate sending data from M4 to A7 4.359 MB/s.Maximal datarate sending data from A7 to M4 9.16 MB/s.Now iam not sure why reading from A7 side is so much slower tha...

Hi,iam a bit confused aboute the remoteproc framework and if my understanding of it is correct.In my view, the remoteproc framework can start the m3 firmware with having its elf-file in a dedicated place of the filesystem. The remoteproc also parses ...

Hi, i have a question regarding to exit the Low Power Mode on CM4. Is it possible that i can exit the CStop or CStandby Mode via an Rx Messages of the CAN Bus, when the CAN Bus is assigned to the M4. Iam confused because almost every Bus is listed in...