About MDebo.1

MDebo.1 · 2020-11-15

Hello everybody,I made for school a custom stm32f103C8Txxx board. Programming with a ST-Link V2 work without a problem.To test the pcb, there are 2 led's (pin pc13 en pa10), they both illuminate every 500ms (easy code to test functionality).The code ...

MDebo.1 · 2020-11-15

But I assume pc13 would still work for just blinking a led? it's the same on a blue pill? Didn't really look into that.

MDebo.1 · 2020-11-15

my code is made in arduino, converted in bin and then uploaded by STM32 ST-LINK Utility.

MDebo.1 · 2020-11-15

Normally HSE.What I did is make a arduino project for blinking led en converted it in bin.It just runs blinking the leds.

MDebo.1 · 2020-11-15

First, thanks for the help.Here is a scoop image:ch1 is resetch2 is the 3V3 rail, it is 3.44V but stil under the 3.6VIt has been running for 5 min and still no changes on ch1 and ch2.Tested the reset and works how it should work when you pull it down...

MDebo.1 · 2020-11-15

By glitches, I mean that the alternating sequense of the leds turning on and off do not work anymore. It just freezes, the led on pc13 does flickers, but way faster than the normal 500ms on/off sequense.All the components for power are on a different...

User statistics

User Activity

STM32F103C8Txxx custom board, glitches after few seconds

Re: STM32F103C8Txxx custom board, glitches after few seconds

Re: STM32F103C8Txxx custom board, glitches after few seconds

Re: STM32F103C8Txxx custom board, glitches after few seconds

Re: STM32F103C8Txxx custom board, glitches after few seconds

Re: STM32F103C8Txxx custom board, glitches after few seconds