Hi,I'd like to use USART for multiprocessor communication. For this I have to configure the TX pin to an open drain mode. But this option is not available: MCU: STM32F446ZEH6STM32CubeMX: 5.1.0Best regards,Eugene

Posted on April 02, 2018 at 17:41Hello ST,I found that code, generated by STM32CubeMX for STM32F4 SDIO periperal, is poorly integrated with MCI interface (CMSIS driver). And doesn't work out of box without modification.STM32CubeMX generates HAL_MMC_...

Posted on March 09, 2018 at 12:36Hello ST,I found that STM32F410 reference manual is incomplete:http://www.st.com/resource/en/reference_manual/dm00180366.pdf There are no bootloader interfaces for UFBGA64 and LQFP48 packages in the table 3 on page 4...

Posted on August 29, 2017 at 09:37Hello,I use NUCLEO-F446ZE board. And I'm trying to lock OTP block 0 by programming 0x00 at 0x1FFF7A00 using ST-Link CLI. I've tried -w8, -w32 and -P commands, but every time utility returns error. STM32 ST-LINK CLI ...