About Alireza Safdari

Alireza Safdari · 2019-08-18

I am using CubeIDE 1.0.2 on Nucleo-F767ZI.=> all settings are the default setting, but ETH and USB_OTG_FS are disabled,.=> The SDIO is enabled (SD 1 bit /SD 4 bits Wide Bus) and has all the default settings, except for SDMMCCLK Clock Divider Factor ...

Alireza Safdari · 2019-10-14

there is an ugly solution as we discussed above but as far as I know it is not resolved.

Alireza Safdari · 2019-10-04

Thanks for the update but is not that weird?

Alireza Safdari · 2019-10-03

HiI have not found a solution yet. But I started accepting it :)I think the files generated by CubeMX and CubeIDE are not the same and I cannot figure out why. for example CMSIS libraries do not get added to CubeIDE but CubeMX does generate them.

Alireza Safdari · 2019-08-18

Hey @norlesh Did you find a work around?

Alireza Safdari · 2019-08-06

@Georgy Moshkin I experienced the same issue. one of the reasons why we can not easily use arm_math.h easily. Alternatively you can install CubeMX and the files will be available there. Hope this helped.

User statistics

User Activity

Nucleo F767 SDIO's Works in 1 bit but not 4 bit? (Cube IDE is Used)

Re: Using DSP libraries (e.g. arm_math.h) in STM32CubeIDE, STM32F4

Re: Nucleo F767 SDIO's Works in 1 bit but not 4 bit? (Cube IDE is Used)

Re: Nucleo F767 SDIO's Works in 1 bit but not 4 bit? (Cube IDE is Used)

Re: Where is the C++ support in STM32CubeIDE?

Re: Using DSP libraries (e.g. arm_math.h) in STM32CubeIDE, STM32F4