Posted on May 19, 2017 at 11:48Good morning, I can’t compile my project to use the Motor Control Workbench 4.3 MonitorI summarize the initial process: Open Workbench, New Project, select Power and control after select NUCLEO-F303RE and STEVAL-IPM05F...

Posted on May 19, 2017 at 09:13I try to run the motor profiler with my custom prototype SM-PSMS motor. In this moments I hold the motor in a big vise, so the motor is impossible to move when start the current. When I run the motor profiling usually ...

Posted on March 06, 2015 at 14:45Hi, I have update SPWF01S firmware at 3.3version and now I need to create a AP with WPA protection. I read in other post who the WPA setting is not supported for AP application, so AP is supported only by WEP standar...