Hello everyone,I am trying to create a CAN project with STM32G431C8 . But there is no data in CANTX pin.I created init codes with CubeMX and codes are below.Here is main function;/** * @brief The application entry point. * @retval int */ int m...

Hello everyone,We are planning to use ST products in our new BLE-supported projects. But I am not sure which product is suitable for this.As I see, there are some BLE chips connectable with SPI and there are SoC ICs like STM32W.I am not sure which is...

Hello everyone.I have never used the STM32W series in any project but I have used nRF52 for our and my BLE projects so many times.It is a great MCU. But we are planning to change the BLE SoC for new projects.So I wonder, is it possible to use STM32W ...

Hello everyone,I have a board with STM32G4 and L6362 on it.But I have several questions about IO-Link itself.I want to know about sensor types on the IO-Link bus.If I want to make an encoder, what type of profile should define, or if I want to make a...

Hello everyone,I have created a project with STM32L151CBU and used UART2 (PA2, PA3) for communication with some other transceiver IC.I have configured my UART as follows for (1-bit start, 8 bits data, 1 bit EVEN parity, and 1 bit stop) communication....