About Bill Dempsey

Bill Dempsey · 2024-08-21

Hi Testing CubeMX 6.12.0 and found a bug. This may exist in other editions. The code generator improperly places the user code comments in the final while(1) loop. This causes MX (and its integration into IDE) to delete all user code. While test...

Bill Dempsey · 2019-07-22

Hi, I am using the LPS22HB and noticed it was reading significantly off after installation. The datasheet and applications notes really don't address this and a good way to correct for it. Could you look at enhancing your application notes or techni...

Bill Dempsey · 2019-02-28

Latest (6.x) release does not support my existing boards and I need to keep these running.

Bill Dempsey · 2019-01-03

HiI have the F446ZE Nucleo board and am using the latest ST supplied demo code from mbed.com to use the CDC as a serial port.The code from mbed compiles without issue and downloads to the F446ZE. At that point Windows attempts to load the CDC driver...

Bill Dempsey · 2018-09-26

Hi, From the st.com website/microcontrollers most of the links from the main page result in a "403 error" when clicking on the links to the various micros (See image below)This is an example link that is currently returning a 403 error. Any idea wha...

Bill Dempsey · 2024-08-27

Awesome post! I have been trying to solve this same issue and just found your post. Once I enabled DMA everything worked great. Now to see if I can get 4 bit mode to work on my board :)

Bill Dempsey · 2024-08-22

Ahhh, I see your point. I was focused on "inside the braces" which worked only when I did my change but you are right there would be no point to nest...I see the "END WHILE" occurring *after* the closing brace so that's what threw me off.

Bill Dempsey · 2020-11-03

Just curious why you used this construct in your code vs "while(1)" as you did in the other functionsvoid _sys_exit(int return_code) { label: goto label; /* endless loop */ }

Bill Dempsey · 2020-10-21

I found a course on the Udemy website which was very good. Directly addresses the STM32 and how to do BLE.

Bill Dempsey · 2019-10-24

Is it April 1? You are kidding , right? Coupling should be DC, not AC.

User statistics

User Activity

Bug found in CubeMX 6.12.0

LPS22HB post solder correction

How do I download an older version of X-CUBE-MEMS1 (V4.4.1) since I am running an older A1 version sensor board

F446ZE CDC Serial demo issue with Windows 7/64

Main website links broken (403 error)

Re: STM32F411RE stm32cube fatfs sdio sdcard always returns FR_DISK_ERR

Re: Bug found in CubeMX 6.12.0

Re: Read NMEA Data via UART STM32

Re: Hi, I'm new to stm32, I have the mcu stm32wb55, does anyone know a tutorial on bluetooth?

Re: Low frequency square wave with distortion