About 庄勇輝.1

庄勇輝.1 · 2020-04-20

I am working with a STM32G474RE and I want to use HRTIM Timer F as PWM with DMA transfer.I used STM32CubeMX Ver.5.6.1 and CubeG4 FW V1.2.0 for generate simplest init. code, which would work only for HRTIM function for HRTIM Timer F.here's my setup a...

庄勇輝.1 · 2020-04-16

I am working with a STM32G474RE and I want to use a MCO as an output of HSE(27MHz).I used STM32CubeMX Ver.5.6.1 for generate simplest init. code, which would work only for MCO function at PG10 Pin. here's my setup.I builded the init. code by SW4STM...

庄勇輝.1 · 2020-04-17

That setting was "LOW" when PG10 output was 1Vpp.I modify it as GPIO_OSPEEDR = "VERY_HIGH".Now, PG10 output amplitude become 3.3Vpp!!And, PA8 still output the same signal as PG10.I want to use PA8 as OPAMP5 OUT(follower).I tried to set PA8 = OPAM...

庄勇輝.1 · 2020-04-17

Thank you for your advice.I read reference manual and HAL API and tried some of programs.But, My work hasn't been going well.PG10 seemed to work, but the clk signal amplitude was lower(1Vpp) than expected(3Vpp). On the other hand, PA8 output was 3V...

User statistics

User Activity

STM32CubeMX bug? STM32G474 HRTIM Timer_F tab could not be set any DMA Request Sources, on the other hand Timer_E tab got an error.

How to use MCO at PG10/NREST Pin with STM32G474RE? Init. code from STM32CubeMX always works at PA8 Pin as MCO function.

Re: How to use MCO at PG10/NREST Pin with STM32G474RE? Init. code from STM32CubeMX always works at PA8 Pin as MCO function.

Re: How to use MCO at PG10/NREST Pin with STM32G474RE? Init. code from STM32CubeMX always works at PA8 Pin as MCO function.