About MMast.11

MMast.11 · 2024-10-11

Greetings.I have a project I developed on ESP32 (CH340 Chip). For some reasons, the project got messy, and I would like to migrate to a new board. I have an STM32 Nucleo which gave me a lot of satisfaction, but for this project I need something-Small...

MMast.11 · 2023-11-20

Good Morning,I am the proud possessor of a Nucelo 746ZG board that has served me well since it has been given to me.Unfortunately for ther last week the Nucleo has a text file with inside the string "The interface firmware FAILED to reset/halt the ta...

MMast.11 · 2023-05-09

MMast.11 · 2020-07-16

The display is a TFT mcufriend-like (http://www.lcdwiki.com/2.4inch_Arduino_Display) based on the ILI9341 chip. I started with the 'Unigraphic-St7920-Test' on mbed to make it work on my Nucleo F756ZG board (https://os.mbed.com/users/charly/code/UniGr...

MMast.11 · 2024-10-14

Thank you all, I really appreciate your time. I will bring this solutions to my team, and they will decide. Both seems good to me. I will wait a couple of days to see if someone else would like to add something, and then I willm ark this as solved.

MMast.11 · 2024-10-14

Yes, this is good. It has everything I need. Unfortunately is more expensive and bigger than of what me and my colleagues are looking for, but this REALLY seems a promising solution.

MMast.11 · 2024-10-14

Yes, the STM32WB seems to be a possible solution. It doesn't have Wifi, but I think it will be fine.

MMast.11 · 2023-11-22

Yes, it still shows with NRST pin groundend. I must have done something dumb without realizing it.I am getting this H473ZI and I will watch out more carefully next time.

MMast.11 · 2023-11-21

It stopped working after I upgraded the firmware, so I believe that something got wrong there.It seems that the H473Zi is a bit more capable and has more peripherals for multimedia (the only think I couldn't do with my Nucleo was to output a working ...

User statistics

User Activity

Could someone suggest me a board?

Suggestion about (broken) F746ZG Nucelo Board

I am developing a board that shall work with a Computer. The last project I developed I was suggested to ask to online support to give a review about my design to optimize it (I have not a very deep knowledge of electronics, after all). Does anyone know h

I want to mount an ILI9341 TFT display on STM32F746; I'm using the Unigraphic Library on MBED, and I can't get it to work.

Re: Could someone suggest me a board?

Re: I need a board (another one)

Re: I need a board (another one)

Re: Suggestion about (broken) F746ZG Nucelo Board

Re: Suggestion about (broken) F746ZG Nucelo Board