I am using a NUCLEO64-G474RE as an SPI master with DMA (Rx and Tx in circular mode) to interface an ADC CHIP. I am receiving data reliably but wish to stop  and start the SPI/DMA . I have used CubeMx to generate the initilisation code and HAL_SPI_Tra...

I want to use an STM32WB module as a ble beacon receiver/detector so I can monitor beacons on my PC using a uart or USB vcom? Are there any examples that can help me and if "Yes" where can I find them?

I have a .lib file created using KeiluV5 and would like to use it in a CubeIDE project. How do I go about doing this?I have found reference to Libraries and Library Paths at Project > C/C++ General > Paths and SymbolsI've tried adding my .lib file a...

I have downloaded the latest version of Cube Programmer and updated my ST-LINK/V2 firmware. I've tried to program connect with a target I have designed and the target cannot be found. Clearly I need to find out why, but that is not my question. Rath...

Hi, I've decided to use some free time to explore LoRaWan. I have experience of ST devices and have a few nucleo boards, (F303 and L433). I bought two lora shields with which to experiment; a I-NUCLEO-LRWAN1 and a SX1272MB2DAS. I've down loaded the l...