About AAdin.1

AAdin.1 · 2024-07-10

Hi, I have used following STM reference design for the buck converter. When I power the circuit output doesn't stabilize. What am I missing? This is from. STEVAL-IHM023V3 Here is my design. Here is the layout Best Regards.

AAdin.1 · 2021-04-14

When I tried to debug my STM32F303RE nucleo board with Truestudio , I get this messages from console:When I get this message , I was working on EXTI interrupts at register levelSTMicroelectronics ST-LINK GDB server. Version 5.1.0 Copyright (c) 2018, ...

AAdin.1 · 2024-07-10

The regulator will supply current to motor controller IC and two relays (edit: there is 3V3 LDO for MCU), there is no steady current at the startup. The supply voltage of the Viper is 310VDC. When I mentioned 15V from bench supply I checked the outpu...

AAdin.1 · 2024-07-10

Output rises and collapses. There is no active load at startup state, when I supply 15V with my bench power supply output circuit draws 0.025Amps. Best regards.

AAdin.1 · 2021-04-14

SOLVED!!It is solved again suddenly :D :D :D I writed this post and ı walked at park about 1-2 hours.When I checked again , I surprised .Anyone can explain why happend this ? -met

AAdin.1 · 2020-03-25

I just wanna say that thank you !!your explanation is great and clearly

User statistics

User Activity

VIPER26LD 310VDC to 15VDC Converter Design Issue

Error in initializing ST-Link device. Reason: (-1) Unknown. Please check power and cabling to target.

Re: VIPER26LD 310VDC to 15VDC Converter Design Issue

Re: VIPER26LD 310VDC to 15VDC Converter Design Issue

Re: Error in initializing ST-Link device. Reason: (-1) Unknown. Please check power and cabling to target.

Re: Convert Arduino code to STM32 IDE code