About PPark.1

PPark.1 · 2021-03-12

I am trying to configure the ADC of STM32L476RGTx to scan three channels, but STM32CubeMX only shows Disabled as an option to select for Scan Conversion Mode. I have also tried this with STM32L471VETx and the same problem exists.Am I missing a prere...

PPark.1 · 2020-03-11

HAL_TIM_OnePulse_Start() sets both Channel 1 and Channel 2 output enable bits. This results in a conflict with the input signal./** * @brief Starts the TIM One Pulse signal generation. * @param htim TIM One Pulse handle * @param OutputChannel TIM Ch...

PPark.1 · 2021-03-12

I should probably add that I needed to Enable Regular Conversions before the 'number of conversions' option became visible.

PPark.1 · 2021-03-12

Many thanks - as with so many things, it's obvious when you're told the answer!

PPark.1 · 2020-03-11

I have just been having the same problem with an STM32F205, and have reproduced the problem with an STM32L476 Nucleo board. The problem appears to be in the HAL_TIM_OnePulse_Start() function. The comments in the function definition say:- /* Enable ...

User statistics

User Activity

STM32CubeMX configuration of ADC for STM32L476RGTx does not allow Scan Conversion Mode to be Enabled

Bug Report: HAL_TIM_OnePulse_Start() [STM32CubeF2 V1.9]

Re: STM32CubeMX configuration of ADC for STM32L476RGTx does not allow Scan Conversion Mode to be Enabled

Re: STM32CubeMX configuration of ADC for STM32L476RGTx does not allow Scan Conversion Mode to be Enabled

Re: One Pulse Mode input can not be driven high enough.