About MGogr.1

MGogr.1 · 2023-09-11

Hi,I'm working with power amplifier for which I have chose stm32f407 controller which monitors ADC, I2C eeprom SPI Flash memory, ethernet , GPIOs and interrupts. when i am doing code development and standalone testing of controller no issue of hard f...

MGogr.1 · 2022-01-04

I tried the changing them, but could not find any difference. If I change that setting will it affect my project in way?

MGogr.1 · 2021-12-27

MGogr.1 · 2021-11-27

I want to interface Stm32 MCU with a NXP MCU over SPI protocol.Does anyone have done that before?? If yes can you please tell me how it can be done? I have already used St and nxp mcus separately and now my application requires both of them together....

MGogr.1 · 2023-09-15

Fault occurs only when input is given through uart and at the same address only. when testing through Beta Analyser in Cube Programmer I got following But I dont think I have any condition where anything is divided by zero.

MGogr.1 · 2023-09-14

Hardware seems to be proper according to me.Could this because of many peripherals running such as ADC,SPI,I2C,FreeRtos and fetching data with uart?

MGogr.1 · 2023-09-13

Thanks for the reply.Can you guide me how to locate this type of error?I'll check once i get back the whole unit.

MGogr.1 · 2023-09-11

please check the library used for eeprom and your function implemention.may be your "NbPages" or "PageAddress" should be "NbSectors"/"Sectors".Do check your flashstruct

MGogr.1 · 2021-12-27

An array of bytes.i want to use i2s function which requires array of music file. How that can be done STDIO file? I didnt understood.

User statistics

User Activity

Going to Hardfault during integrated testing

Can anyone explain me what is "Linker Setting" in Cube IDE?What will happen if I change the minimum Heap size and Stack size? The linker setting can be found in Project manager while initialising the project.

Does anyone know software which can convert my audio .wav file to C code? I'm trying to use i2s on my stm32 board but the output i am getting is gibberish audio. Currently I have used Wav to code software but i'm not satisfied with it.

Interfacing Stm32 with NXP controller over SPI.

Re: Going to Hardfault during integrated testing

Re: Going to Hardfault during integrated testing

Re: Going to Hardfault during integrated testing

Re: STM32F401RCT6 EEPROM Emulation

Re: Does anyone know software which can convert my audio .wav file to C code? I'm trying to use i2s on my stm32 board but the output i am getting is gibberish audio. Currently I have used Wav to code software but i'm not satisfied with it.