About david cambridge

david cambridge · 2019-01-02

Hi - stm32 cube mx version 5 is running very slowly for me (I've a good spec i7). Does anyone have any suggestions?

david cambridge · 2017-12-02

Posted on December 02, 2017 at 18:59HI I've been trying to get an SD card working in 1bit mode using the SDIO peripheral. I am failing, and would appreciate some help. I'm on a Nucel401RE using STM32Cube_FW_F4V1.180.0The pin configuration is below. ...

david cambridge · 2019-04-23

If it helps, I asked the same question of ST support and received the below answer. thanks for putting a request on our web site, we are pleased by your interest in our products. Unfortunately, the only officially supported IDE for the time being wit...

david cambridge · 2019-01-02

I should add that earlier versions (prior to the MMI update) ran fine

david cambridge · 2017-12-04

Posted on December 04, 2017 at 23:25I was trying to keep the project as simple as possible, so everything was at it's default values (i.e. I didn't do anything to enable DMA that didn't happen automatically)

david cambridge · 2017-12-04

Posted on December 04, 2017 at 22:39You'll find it in STMCube, go to the configuration tab, and choose the configuration for the FATFS, and then it's in the second tab along (IP Instances)

david cambridge · 2017-12-04

Posted on December 04, 2017 at 11:27Hi Problem now solved, I needed to set Stm32Cube\Configuration\FATS Configuration\IPs instances\Use DMA template to 'disabled' - and then it worked!David

User statistics

User Activity

STM32CubeMx version 5 is very slow

SD Card using 1 bit SDIO on Nucleo 401Re

Re: TrueSTUDIO, CubeMX, TouchGFX template/example for a STM32F469 Discovery Board

Re: STM32CubeMx version 5 is very slow

Re: SD Card using 1 bit SDIO on Nucleo 401Re

Re: SD Card using 1 bit SDIO on Nucleo 401Re

Re: SD Card using 1 bit SDIO on Nucleo 401Re