About lospaul

lospaul · 2022-10-13

Hi community,I'm using a LIS3DH MEMS on our propriety board with a ST32L476 MCU.When trying to read x, y, z, channels I get correct data for y and z, but x (Registers 0x28 and 0x29) always return 0x80 0x80.Sometimes after power up the board, all thre...

lospaul · 2023-03-23

We are facing the same problem and tried the same steps to solve it - without success.This is really a pain in a distributed project with people checking out the projects in their workspace. It makes the template feature nearly unusable.Has anybody f...

lospaul · 2022-10-26

Hi @Eleon BORLINI ,thank you for your reply.Unfortunately we face the issue on most, but not all of our boards.Sometime a board working ok for a while starts to show the strange behaviour without any writes to the reserved registers. Find below a pi...

lospaul · 2022-10-25

Thanks again.The problem is: We first had the erroneous behaviour and than started looking for a difference and changing reserved registers.I still don't know what we are doing wrong other then changing reserved registers at a device which for an unk...

lospaul · 2022-10-25

Hello @KHALSI_Foued thank you for your reply!Yes, I know I shouldn't do it and I wouldn't do it if the LIS3DH would give me correct values.But it doesn't and a write to Register 0x10 is the only way to motivate the sensor to give the correct values ...

User statistics

User Activity

LIS3DH polling acceleration data only work with patching Register 10h

Re: Support relative paths in IOC file

Re: LIS3DH polling acceleration data only work with patching Register 10h

Re: LIS3DH polling acceleration data only work with patching Register 10h

Re: LIS3DH polling acceleration data only work with patching Register 10h