About Rvan .9

Rvan .9 · 2022-11-23

Good day. So I am busy with my final year project, where the goal is to control the speed of a DC motor by reading the armature voltage and current, and then estimating the speed of the motor. I am using the STMCubeMonitor to provide a reference spee...

Rvan .9 · 2022-10-30

Good day, I am trying to get a simple "counter" variable which just increments the counter by 1 every second, to display on my Chart in Cube Monitor, and have followed the instructions given in the STMicroelectronics youtube video - https://www.yout...

Rvan .9 · 2021-10-20

Hi, I am using the STM32 Nucleo F446RE board. I have accidentely changed the PA13 pin, which is assigned to the debugger to a GPIO output pin, which resulted in my debugger not working and now I can't load any new code on the STM. How do I change bac...

Rvan .9 · 2022-11-23

Good day Stephane , I managed to sort it out thank you, something was wrong with the building blocks I used, I reverted back to the blocks given in the template and set up everything from there and managed to get it to work thank you.

Rvan .9 · 2021-10-20

These are the settings in my programmer but when I click connect it shows that it is picking up the board in the log but it keeps showing that the target isn't found

Rvan .9 · 2021-10-20

So this here is my board, my NRST Pin is just above my 3V3 Pin, so I am not sure what you mean by holding NRST low briefly, and should I be doing anything else in the programmer at this time?

Rvan .9 · 2021-10-20

So I used the STLink Utility App and these were my settings, as soon as I press Okay I get the following :Then when trying to erase the chip, it gives the same error. I watched a few videos and most of the poeple just press the reset button (which I ...

Rvan .9 · 2021-10-20

I am fairly new to STM32 boards. Can you advise me how to do this, because I have tried booting into the bootloader and to do this I connected the 3.3V pin to the Boot0 pin, but I'm not sure where to go from there

User statistics

User Activity

My STM32 keeps disconnecting from my computer during runtime when using STMCubeMonitor.

My cube Monitor is not displaying my variable values to the Chart

STM32-F446RE Nucleo board lcan't connect via ST-Link

Re: My cube Monitor is not displaying my variable values to the Chart

Re: STM32-F446RE Nucleo board lcan't connect via ST-Link

Re: STM32-F446RE Nucleo board lcan't connect via ST-Link

Re: STM32-F446RE Nucleo board lcan't connect via ST-Link

Re: STM32-F446RE Nucleo board lcan't connect via ST-Link