About SSalm.1

SSalm.1 · 2023-01-23

SSalm.1 · 2022-01-19

SSalm.1 · 2021-09-23

Hello,I am using a STEVAL-ISC004V1 to power up a device (PD sink) that needs 24W (15V 1.6A) power supply to power up and charge the battery. When I connect the STEVAL-ISC004V1 to the device the VBUS LED does not show a solid green and flashes. My dev...

SSalm.1 · 2023-01-24

Thank you for your response. That is what I thought too but wanted to check to make sure. Does this mean that in VNS3NV04DP-E the ILIMH 3.5A is shared between 2 MOSFETs since it does not have the "Per each device" note? Is RDS(ON) value the main diff...

SSalm.1 · 2022-06-30

Hello,I know this is an older post but I am trying to program a custom board using the UART code and a Nucleo-F072RB board and having problem connecting to the board. I went through the process multiple time and flashed the NUCLEO board multiple time...

User statistics

User Activity

Is each MOSFET current limited to 1.7A in VNS1NV04DPTR-E? Or total current for the chip (both MOSFETs together) is limited to 1.7A?

I am using STUSB4710AQTR in a USB C PD. I designed my circuit based on STEVAL-ISC004V1 schematic, but I’d like to use A5973ADTR instead of ST1S14PHR. can I use A5973ADTR the same way that ST1S14PHR is used in this circuit?

STEVAL-ISC004V1 VBUS LED blinks when I am trying to power up my device.

Re: Is each MOSFET current limited to 1.7A in VNS1NV04DPTR-E? Or total current for the chip (both MOSFETs together) is limited to 1.7A?

Re: FAQ: How to configure the STUSB47 on a custom board ?