About kelvin.wang

kelvin.wang · 2023-12-07

[VERSION]: MCSDK 6.2.0[TOOL]: MC WB,[DETAILS]: PWM output Abnormal [EXPECTED BEHAVIOR]:M1 & M2 should drive independently & smoothly[HOW TO REPRODUCE]:1.Profile M1 & M2 by Motor Profiler with EVSPIN32G4. M1 & M2 got Hall .2.Use MCSDK 6.2.0 with EVSPI...

kelvin.wang · 2021-06-15

I download "STSW-SPIN3204" and compile with Keil .When open the project . Warming message shows"FrameworkCubeMX.gpdsc"is missing. How to solve it?

kelvin.wang · 2024-07-09

MCSDK 6.3 Profile need user to add FW manually by create new project ,you may refer to MCSDK document in "about" ICON and search "Motor Profiler Application Note"

kelvin.wang · 2024-07-08

And, the motor is currently driven by the user1 button. However, if I remove the USB that was used to debug the STEVAL-SPIN3204, the motor does not run even when I press the button. I don't know which part is wrong.==========>MCU VDD is drived by US...

kelvin.wang · 2023-12-18

Hi Gael A, That means if I swap 2 motor then I will not encounter the protection & stop issue ? Right ?

kelvin.wang · 2023-12-10

Hi Gael A,- Are you using the MotorPilot to start/stop your motors ?====>Yes- If yes, is it returning any error when your motor stops ?====>Driver Protection- When you say : "M1 stop with high frequency noise", do you mean that your motor stops then ...

kelvin.wang · 2022-05-22

steval-spin3204 support 6step only. If you want to generate code by MCSDK, you can only use the example code listed below the MCSDK.

User statistics

User Activity

EVSPIN32G4-Dual driver 2 motor issue

About STSPIN32F0B code for STEVAL-SPIN3204 Keil Compiler issue

Re: How do I measure motors with the EVSPIN32G4 board?

Re: [STEVAL-SPIN3204] MCSDK ~ STM32CubeIDE BLDC Motor Control

Re: EVSPIN32G4-Dual driver 2 motor issue

Re: EVSPIN32G4-Dual driver 2 motor issue

Re: Where can i get the firmware of steval-spin3204??