1.Using the STSPIN4G chip, after enabling the timer output, an error message will be reported stating a short circuit and the motor will not run.2.The upper arm of the entire bridge MOS is conductive, while the lower cliff is disconnected. Want to kn...

1.After generating the code, this. a file will directly display an exclamation mark;2.I deleted this file again and then loaded it in. Compilation still reports errors. 3. The error message is as follows: There are no Chinese characters in the path. ...

After generating STSPING4 using MC Workbench and opening it with CubeMx, it becomes an STM32G431VBTx chip? There are 100 pins, which do not match the packaging of STSPING4. The generated code cannot be used either.

{ "type": "inverter", "name": "EVSPIN32G4-mini", "descVersion": 4, "contentVersion": "1.0", "PN": "EVSPIN32G4", "shortDescription": "STSPIN32G4 demonstration board for three-phase brushless motors", "longDescription": "STSPIN32G4 demonstration board ...