About LucaP

LucaP · 2025-03-01

I am using the STM32F723 with custom, self-powered PCB interfaced to a host using USB HS. Everything worked fine with with CubeMX 6.12, but after upgrading to more recent versions, I noticed that the following functions are no longer generated within...

LucaP · 2022-07-03

I am sending a fixed-sized buffer (512 byte) at 8 Mbits/s via UART out of an STM32F3, and I am experiencing what it seems to be a fixed delay (~ 2-3 bit periods) between consecutive frames. In the screenshot below, after sending the dummy value 01010...

LucaP · 2025-03-11

Thank you, @FBL In these cases, would a fix be typically released in a major release like CubeMX 6.15, or a minor release sooner?

LucaP · 2025-03-06

Done, please see reply to @TDK above.

LucaP · 2025-03-06

Sorry for missing your request....attached are IOC projects created from scratch with CubeMX 6.12 and 6.14 respectively, based on the same MCU with only a HS USB and CDC activated. As you can see, usbd_conf.c generated by 6.12 calls the functions abo...

LucaP · 2025-03-04

Hello @FBL ,I have tried migrating the IOC from 6.12.1 to 6.13 and then to 6.14, also from 6.12.1 directly to 6.14, but in all cases those functions are no longer generated by CubeMX.Anything else I should try?

LucaP · 2024-04-04

I am not saying that it is hard per se, but since I have read about different people have different outcomes with the T-VCC and the OP seem to have the exact same setup/tools/needs that I have, I though that hearing his/her experience could be useful...

User statistics

User Activity

USB HS clocks not started from CubeMX 6.13 onwards

Delay between UART TX frames at high speed

Re: USB HS clocks not started from CubeMX 6.13 onwards

Re: USB HS clocks not started from CubeMX 6.13 onwards

Re: USB HS clocks not started from CubeMX 6.13 onwards

Re: USB HS clocks not started from CubeMX 6.13 onwards

Re: Is it possible to use the STLINK V3 CN1 without T_VCC?