About KSzul.1

KSzul.1 · 2022-08-28

If yes, which one? 5.4.8 or 5.Y.4? How did you configure it?My experiences so far:cannot connect to MotorPilot from 5.Y.4, tried different COM Port baudrates configured both in MotorPilot and CubeMXcan connect to Monitor in 5.4.8 with baudrate 9600co...

KSzul.1 · 2022-08-14

My setup:NUCLEO-F446RE and STEVAL-IPM15B"ST Motor Control Workbench" "Power Stage - Current Sensing" settings:Shunt resistors value: 0.04 Ohm (also on PCB, but User Manual um-2014-1500-... says 0.08 ohm, another mismatch)Amplifying network gain: 2.10...

KSzul.1 · 2022-10-04

Not yet, but I am not going to give up and will let you know here how its going (once I'll have some time to work on that controller).

KSzul.1 · 2022-09-27

I will try to bump this topic as I did not moved any further with this issue. I have no idea how to make this board working, the MOSFETS are OK, I cannot find any info about using this board anywhere.Can anybody help me with that?Thanks

KSzul.1 · 2022-09-01

Hi Cristina, thank you for your answer.I guess I have solved dropping connection issues, the problem was with USB cable. I have shared the Idea here:https://community.st.com/s/idea/0873W000000fy30QAA/detailHowever, I did not managed EVSPIN32F0602S1 b...

KSzul.1 · 2022-08-12

Hi,I did not get that far yet in my learning and discovering what MC can do. Your problem sounds like there is not enough power to keep desired speed.What I have found recently is that playing with PWM frequency and dead time for driver and power sta...

KSzul.1 · 2022-08-10

Hi, I was going through a similar situation. I'm completely the beginner but I think I managed to figure it out, it works for me now.First configure Iq PID gains Kp and Ki as ST suggests, with current probe and oscilloscope. That took me most of the ...

User statistics

User Activity

EVSPIN32F0602S1 - did anybody make it work with ST MC Workbench?

Bug in Motor Pilot V0.9.20 from ST MCW 5.Y.4.21553 Rev-up Phases Configuration?

Re: EVSPIN32F0602S1 - did anybody make it work with ST MC Workbench?

Re: EVSPIN32F0602S1 - did anybody make it work with ST MC Workbench?

Re: STM Workbench - Communication closed, the board doesn't respond correctly

Re: How to run high voltage PMSM with STEVAL-HKI001V2 board?

Re: How to run high voltage PMSM with STEVAL-HKI001V2 board?