About YIzAKat

YIzAKat · 2021-07-04

I've just switched to working on an STM32F411-E DIscovery. Starting a new project (STM32CubeIDE) and allowing it to populate the default peripheral config for the board is generating code that will not run (at least not for me).The clock configuratio...

YIzAKat · 2020-10-29

Debian Linux : 4.19.152-1 (xfce 4.2 desktop manager)STM32CubeIDE : 1.4.2 Build 7643_20200813_1322Howdy, I'm not sure if this is just a local problem to my installation of Linux or a more general issue. If I attempt to update the user labels using th...

YIzAKat · 2023-07-22

Absolutely a low priority - but it catches me every time :) My muscle memory anticipates the debugger pausing at the start of main() and I usually automatically hit F5 to continue (I don't want to disable this because sometimes I need it to stop the...

YIzAKat · 2021-07-04

A final follow-up for anybody else encountering this thread/problem. Things work well enough if you change the default HSE/LSE in the Cube from Bypass to Crystal. I have found though that going back into the configuration a second time to change anyt...

YIzAKat · 2021-07-04

Thank you both, yep my guess is that this is because the Nucleo boards I have used source the clock from ST-Link MCO (no crystal fitted) by default and the same invalid default has been generated here. I've checked my various Discovery boards and a...

YIzAKat · 2020-12-29

Hi Will,Yep OK. I do have a DSO so will do exactly what you've suggested, I have also used instrumented code with Segger's SystemView which helps monitor tasks/ISRs but is subject to timing issues itself depending on load. Sounds like quite a simil...

YIzAKat · 2020-12-29

Thanks Will, I doesn't seem like there is a specific reason why that priority was chosen other than 'it can use it because it doesn't do much'. I'll go with Pavel's view that is just increments a counter and shouldn't impact my ISR servicing the samp...

User statistics

User Activity

Out-of-box Cube code generated for STM32F411-E DISCO doesn't run. Error_Handler triggered in clock configuration.

Is anybody else seeing keyboard entry freeze when updating user labels from the LH panel in the Device Configuration Tool?

Re: How to disable opening startup_stm32<mcu>.s file after using Run configuration.

Re: Out-of-box Cube code generated for STM32F411-E DISCO doesn't run. Error_Handler triggered in clock configuration.

Re: Out-of-box Cube code generated for STM32F411-E DISCO doesn't run. Error_Handler triggered in clock configuration.

Re: STM32CubeMX fixes timer interrupt priority for HAL timer if RTOS enabled?

Re: STM32CubeMX fixes timer interrupt priority for HAL timer if RTOS enabled?