How do you perform a soft reset on the VL53L4CD if XSHUT is not used?  I can't seem to find an example.  I see the VL53L4CD_ULP_SOFT_RESET or VL53L4CD_SOFT_RESET is defined, but I don't know what to write to it.Also, how do you shut the sensor down w...

I am trying to use the VL53L4CD as a low power tamper sensor so that it interrupts when someone removes a lid.  I am using the ULP driver and I pulled in SetDetectionThresholds from the other driver.  I have been able to configure it to interrupt whe...

I have STM32CubeIDE Version 1.15.1 installed and was unable to open an example for the STM32U575 because the installer said:Other downloads worked fine and I checked the connection in the Firmware Updater:I have other previous versions installed but ...

@John E KVAMI ported the gesture recognition example (STSW-IMG035_F401) from the STM32F401RE to the NUCLEO-U575ZI-Q with the X-NUCLEO-53L8A1 and the gesture library (STSW-IMG035_M33).  If I used the VL53LMZ_ULD_API driver included with the GestureKit...

Hello, I am trying to get gesture detection (swipe UP, DOWN, LEFT, RIGHT) with the VL53L8CX working on an STM32U575 running an RTOS.  I currently have a X-NUCLEO-53L8A1 plugged into a NUCLEO-U575ZI-Q board running Segger embOS in a C++ project.  I ha...