About Billy Bob

Billy Bob · 2018-04-17

Posted on April 18, 2018 at 06:00Hi,I feel like I've been through the reference manual a million times, but I cant figure out how to get my project into low power mode.I'm driving a LCD screen with a counter on it. I have two external switches to wa...

Billy Bob · 2017-01-05

Posted on January 06, 2017 at 05:39 I have a custom LCD that I am trying to drive with theSTM8L052C6. I have tested the LCD with 2 other MCUs and it works fine. However, when I try to drive it with the STM8, it is very dim and almost not visible....

Billy Bob · 2018-05-09

Posted on May 09, 2018 at 07:36Thanks. I was able to get it to work with that example code. I've noticed I can still only get it to work if I compile for 'Debug' because if I compile for 'Release' and load that onto the unit, it never goes into low ...

Billy Bob · 2018-04-21

Posted on April 21, 2018 at 23:11Okay, I really need help. I just started a new project with nothing in it. Everything is default. All I am doing is calling halt. #include 'STM8L052C6.h'void main(void){ {_asm('HALT\n');} while (1);}When run...

Billy Bob · 2017-02-15

Posted on February 15, 2017 at 10:30Thank you!The problem was that I didn't have a capacitor placed on the VLCD pin. This was frustrating because it seemed like things would sometimes work, but if I slowed down the clock or even enabled LCD_CR2.HD t...

Billy Bob · 2017-01-12

Posted on January 13, 2017 at 06:26Thanks for the response. I tried setting that bit again just to be sure. For some reason, when that bit it set, the LCD is nearly invisible. It might be completely off. I don't have my scope with me to check, but i...

User statistics

User Activity

Cannot enter low power mode STM8L052C6

STM8 not driving LCD

Re: Cannot enter low power mode STM8L052C6

Re: Cannot enter low power mode STM8L052C6

Re: STM8 not driving LCD

Re: STM8 not driving LCD