Dear ST team,I tried to use CubeX, did not able configured as needed. I done separate two timers, the results are not accurate and lots of jitter without any other application.Need - Using GPS receiver's PPS output to aligned the sampling of external...

I need to calibrate the internal timer to do ADC sampling using GPS receiver.The accuracy of measurement is most important (zero or minimum jitter), PPS output of GPS receiver is input.Thanks in advance

Posted on January 04, 2014 at 16:16I am using Keil 4.72, STM32F100VB with STLinkV2 for debugging purposes. When system is in debug mode, it looks perfectly but if I flash the chip and run in non debug mode (with SWD connected or removed), firmware d...

Posted on December 31, 2012 at 19:28Dears, I have problem while debuging the code for STM32L151RDT6. I get every time the hard fault exception with bus fault. Description of Project: I am using KEIL 4.54 with ST Link/V2. The system has SPI FLash (8M...

Posted on February 23, 2013 at 05:03I am using STM32F100CB in my application. I am also using the example code of UART Interrupt. The Receiver section is OK. For Transmission by interrupt. I do not understand how to start 1st byte. (In 8051, used l...