Posted on January 06, 2012 at 05:55  I wanted to verify that when my HW over current circuit asserts the over-current signal that the effect on the software is the same as an ESTOP. Or does this input act like a chopper and only terminate the PWM s...

Posted on December 29, 2011 at 03:28[Resolved]: When the Over-current protection disabling network check box is clicked on the (Power Stage - Over Current Protection) page the port and pin values can then be changed. -------------------------------...

Posted on December 10, 2011 at 10:48 Is there a document that shows how to interpret the ''flags'' and ''status'' (Serial communication) register when read from the processor. I can query and receive the u32 Flags data and the u8 status data but the...

Posted on November 29, 2011 at 23:48  I'm reviewing the user manual for the http://www.st.com/internet/com/TECHNICAL_RESOURCES/TECHNICAL_LITERATURE/USER_MANUAL/CD00298474.pdf (Doc ID 18458 Rev 2) and I have a few questions. Table 37: Page 112/122 sh...