I try to connect STM32H750-DK with STM32CudeProgrammer but it shows as the picture. What should I do?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2023-03-08 12:28 AM
20 REPLIES 20
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2024-04-09 6:03 PM - edited 2024-04-09 6:04 PM
On the version I had it was a resistor pad, the pads needed bridging.
There are several PCB revisions, perhaps pull the schematic from the "CAD Resources" tab of the product page
State which version of the board you have.
Provide a picture of your board at a similar resolution and focus as I provided, ie very large, very clear.
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..

- « Previous
- Next »