STM32MXCube : How to Configure Push Pull PWM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2022-08-28 6:59 AM
Hi,
I have control H-bridge with 4 MOSFET .
MCU: STM32G071RB
PWM Topology : Push Pull Mode (Not Complementary)
PWM Frequency : 10KHz.
Dead Time : 2.5us
Duty Cycle : 0% to 50%
Emergency Stop : 2 Fault Pins for Individual Channels
How to generate Push Pull Mode with PWM Fault pin/Shutdown CubeMx for 2 channels with TIM1 with Above configuration:
Will that possible ?
--
Karan
Followup Threads:
https://community.st.com/s/question/0D53W00000yVEbRSAW/detail
https://community.st.com/s/question/0D53W00000yVedLSAS/detail
Labels:
- Labels:
-
STM32CubeMX
-
STM32G0 Series
-
TIM
This discussion is locked. Please start a new topic to ask your question.
0 REPLIES 0
