UART4_RX and UART5_RX requests were not downloaded
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-08-20 6:56 PM
HI everyone,
Sorry I am not familiar with STM32Cube IDE.
After I created a workspace for my project, I encountered an warning message that says "UART4_RX and UART5_RX and UART4_TX and UART5_TX_DMA requests were not loaded."
If I encountered this, what is the possible solution for this? Thank you.
- Labels:
-
STM32CubeIDE
-
UART-USART
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-08-20 6:58 PM
Never seen that before. Can you share your IOC file?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-08-20 11:41 PM
Attempt to fit a project made for a different mcu, into a model which does not have those two UARTs?
Or consequence of ST messing unnecessarily with naming UART/USART?
I don't use Cube.
JW
