Ask questions on the STM32CubeIDE for Visual Studio Code extension. Find answers on a variety of topics, including build issues, debug functionalities, CMake project integration, and feature requests for CubeCLT installation.
STM32Cube for Visual Studio Code Extension Pack promoting STM32Cube experience Pre-release information This release represents a major advancement in delivering a comprehensive and efficient VS Code-based development environment for STM32 microcontro...
I have setup a project with a Nucleo-STM32F429ZI.I can successfully start the debugging once.But when I press stop (red square in overlay menu) and then "Start Debugging (F5)" (green driangle in the "run and debug" sidebar) again, it hangs at13-targe...
Greetings,I am configuring the STM32 VS Code extension for Visual Studio Code. After configuring the CubeCLT, CubeMX, and STMCUFinder extensions with the corresponding paths in the extension, I create a new project from CubeMX configured as CMake. I ...
I started using stm32 MCU's on my university. There we used the CubeIDE. Now I have a board at home for own projects. I wanted to use VSCode with the new extension, because i prefer it over Eclipse / CubeIDE. Now I have two questions. I can debug my ...
Trying to debug my code in VSCode using the Cortex-Debug extension, however, I cannot seem to locate the SVD file for the STM32U073CCTx MCU. The CAD Resources tab for the STM32U073CC does not show anything other than footprints. Any ideas where I ca...
Hi, i wanted to export this Project:https://github.com/mirzafahad/nucleo_stm32f429zi_lwip_examples/tree/master/UDP_Echo_Clientto CMake, so i can import it via the STM32 VSCode extension. I was following this short Video: https://www.youtube.com/watch...
I recently started working the STM32 project on VS Code. I could apparently compile it with no problem. However, I have a very hard time trying to make the debugging work. Error looks like this: Normally there should be a place to configure the debu...
Hi,I have successfully installed STM32 vscode extension (v2.0.1) and able to create and build new projects with various MCU.However, I can't find STM32H757ZI from the device list presented by the extension.How can I fix the problem?
Hello, I'm working on a project for a Nucleo board for which I'm trying to use VSCode. I've installed the relevant extensions, and building and running the project had been working, but suddenly (after changing the .ioc file in CubeMX) it stopped wo...
I'm trying to use VS code to flash/debug my Stm32F407VET6. When I tried to flash I got following terminal output: "xpack-openocd-0.12.0-3/BIN/OPENOCD.EXE" -f ./openocd.cfg -c "program build/Stm32F4_Hello.elf verify reset exit" xPack Open On-Chip ...
When using STM32 VSCode extension stlink simulation debugging，how to set Rest behaviour and suspend watchdog counters while halted?
