UCOS porting problem

[Rahimi.Meysam]

Posted on February 10, 2015 at 22:09

Hi

I have the Problem: I have ported and tested a uCOSII on stm32f4/discovery(STM32f407VG) evaluation board with out any problem(board Programmed with onBoard STLINK).after that i have tried to program a custom board with STM32f407ZG with Jlink.i have no problem with simple programs but the program that worked on the evaluation Board, when get to the ''enable interrupt processor level'' at the uCOSII resources jump to the 0 address of Memory and THis Warning appeare: warning t-bit of xpsr is 0 but should be 1. changed to 1The same event occurs when I port UCOSIII. can anybody please help me what is the problem? I cant Figure out!!thank you #stemwin #ucos-iii

[Tesla DeLorean]

Posted on February 10, 2015 at 23:00

Please don't [DEAD LINK /public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/Flat.aspx?RootFolder=/public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/STM32F407ZG&FolderCTID=0x01200200770978C69A1141439FE559EB459D7580009C4E14902C3CDE46A77F0FFD06506F5B&TopicsView=https://my.st.com/public/STe2ecommunities/mcu/Lists/cortex_mx_stm32/AllItems.aspx&currentviews=6]cross post to multiple forums here.