Unable to do In-System programming but Debug works STM32
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2010-01-02 01:00 PM
Posted on January 02, 2011 at 22:00
Unable to do In-System programming but Debug works STM32
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2011-05-17 05:20 AM
Posted on May 17, 2011 at 14:20
I think i figured it out..
my BOOT0 was not grounded. I had to press RUN in the STM32 ST-LINK Utility-> MCU core to get it working when BOOT0 was floating.Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2011-05-17 05:20 AM
Posted on May 17, 2011 at 14:20
Nothing special yet... i was turning on/off relays, DAC output.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2011-05-17 05:20 AM
Posted on May 17, 2011 at 14:20
''program doesn't do what it should''
So what does it do?