STM32L071 i2c busy
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-11-01 6:19 AM
Try run i2c1 in master mode. After set START bit both SCL and SDA lines goes LOW and remain until reset peripheral.
Solved! Go to Solution.
Labels:
- Labels:
-
I2C
-
STM32L0 Series
This discussion is locked. Please start a new topic to ask your question.
1 ACCEPTED SOLUTION
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-11-01 7:00 AM
Solved. Wrong pull-up resistors were placed
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-11-01 7:00 AM
Solved. Wrong pull-up resistors were placed
