An4013 "STM32 cross-series timer overview" possible errors

[Uwe Bonnes]

Hello,

I think following things in 2.4 Timer output compare mode are wrong:

3d) Enable the capture / compare output by writing CCxE in CCMRx register.

should read

Enable the capture / compare output by writing CCxE in CCERx register.

and

CCx update rate = CK_CNT / TIMx_CCRx

should read

CCx update rate = CK_CNT / TIMx_ARR

[Khouloud GARSI]

Hi @Uwe Bonnes​ ,

Thanks for your feedback!

You're right regarding the first point. I will highlight this to be fixed in the next release of the application note.

Regarding the CCx update rate, I will further check this point and update you ASAP.

Khouloud.

[Khouloud GARSI]

Hi @Uwe Bonnes​ ,

Your feedback is already reported internally and those two points will be fixed in the next release of the AN.

Many thanks!

Khouloud.

[Khouloud GARSI]

Dear @Uwe Bonnes​ ,

The new release of AN4013 is now available on ST website.

The two points that you have highlighted are fixed. Thanks again for bringing them to our attention!

Link to the AN:

https://www.st.com/content/ccc/resource/technical/document/application_note/54/0f/67/eb/47/34/45/40/DM00042534.pdf/files/DM00042534.pdf/jcr:content/translations/en.DM00042534.pdf

Khouloud.