I currently done the code for bldc motor working in stm32 cube ide .I am using STM32F103C8T6. What I need to change in my code to control my motor using HAL sensors?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2023-03-12 11:06 PM
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2023-09-08 1:32 AM
Hello CS S.1,
First we would like to apologize for the delay in replying to your post.
If your point is still relevant : Hall Sensors speed sensing can be enabled via Workbench by clicking on Drive Managements, and selecting Hall Sensors in the scrolling menu, as shown in the picture :
If you agree with my answer, please consider accepting it by clicking on 'Accept as solution'.
Hope this will help,
Gaël A.
Hope this will help,
Gaël A.
