Communication
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2025-03-21 6:05 PM
Hello, I'm working with the ST EVAL3201 motor controller board. I'd like to use an STM32 Discovery board to send commands to start and stop the motor. Is this feasible? If so, could you provide guidance on the necessary connections and communication protocols?
Labels:
- Labels:
-
6-Steps
-
MC Workbench
-
STM32 Motor Control
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2025-04-22 5:54 AM
Hello @AnilAJ,
Refer to User Manual documentation available through "Workbench tool">About>Documentations>Documentation>"User manual" tab, "Motor Control Protocol Suite" link for Motor Control Protocol description.
If you agree with the answer, please accept it by clicking on 'Accept as solution'.
Best regards.
GMA
Best regards.
GMA
