ST link not working

[rajan2]

Posted on October 02, 2011 at 14:29

Hi everyone,

I recently bought a STM32 discovery board and it seems that the ST-link is not functioning properly when I run ST-link utility it says no ST link detected, I made sure that it is in SWD mode and I have got two jumpers connected on CN3(I have attached a photo of my setup). I am new to this and I'm not sure what might be going wrong so any help will be appreciated.  #st-link-not-connected-discovery

[evgentusbachinintus]

Posted on July 27, 2012 at 03:04

I find a short video about this problem which advices some ways to solving this problem. I was approached last piece of advice

 Here is the Youtube Link 

http://www.youtube.com/watch?v=2mNc-v-OWSY&feature=plcp