How to stop RF activity on STM32WB55RG

[Born2]

I am using Zigbee wireless communication using STM32WB55RG. I would like to reduce the current consumption to 1μA after it has finished its role, but the current does not go down. What should I do now

[Ouadi · Accepted solution]

Hello @Born2,

Which role are you using for your device ?

Please note that the Sleepy End Device role is the best configuration possible for low power consumption, The SED manages its power consumption in a low-power state with the radio networking off most of the time.

You can refer to the document below describing how to develop a sleepy end device on ZigBee network supported by the STM32WB series:

developing-zigbee-sleepy-end-devices-on-stm32wb-series-stmicroelectronics.pdf 

Best regards

Ouadi