Posted on February 29, 2016 at 12:38Hii have a problemi build ac dc converter based on flyback and i get in outpout sawtooth with rippel 1v i should get stable voltage in outpoutinput: 110-230Vac,outpot 12v 1Ai used chip viper37LD and isolated feedb...
Posted on February 17, 2016 at 18:49I'm trying to design a constant current driver in eDesign Studio using the ST1CC40DR chip. I've set my output requirements to 4.8V and 1.2A and the input is 12V DC. With a 2% LED ripple current and 10% inductor ri...
Posted on December 16, 2015 at 11:23HI, I have designed a isolated flyback using VIPER37LD in eDesign Studio and found the schematic is matching with the expected.but i want to conform the components value through design calculation.so i request you...
Posted on August 17, 2015 at 21:48My first project using the tool eDesignSuite and I'm developing a switching power supply with a 85VAC to 265VAC input voltage with 24VDC output and 5A of output current. My difficulty is in finding the transformer t...
Posted on August 27, 2015 at 15:25Hello , I am designing a battery charger using this IC ALTAIR05T-800 but wurth transformer part no. is not mention as if i search on wurth site it doesnt exit.Plz provide me the transformer part no. and whic...
Posted on July 21, 2015 at 11:07Hello, I design DC-DC converter using eDisign and I make it with folowing parameters: Vin = 11-14 V Vout = 5 V Iout = 700 mA Design software limits maximal inductance for this IC to 10uH, but then IL ripples are quite...
Posted on June 23, 2015 at 15:42Hi, I'm evaluating SPC560-Disp discovery kit and EVAL-L9958 board for one of my project. We are trying to build a fixture which will send some commands to control the motors through USB(most likely a VCP). In general ...
Posted on May 07, 2015 at 19:14Hello I built a SMPS using the eDesignSuite. It is based on a Viper28, and was designed to output 15V 750mA from 80-265V AC. I wound my own transformer based on the specs from the design. Under no load the output is 14...
Posted on February 02, 2010 at 14:32eDesignStudio simplifies power supply design and offers to designers the flexibility to choose the right products and topologies. A full design is generated from the high-level requirements specified by user and...
Posted on March 13, 2015 at 11:18Whenever I try to start a Project using the a VIPERxxx non-isonalted AC/DC buck converter I get the following error message: HTTP Status 404 - /analogsimulator/flex_app/bin/assets/config/smps_app_acdc_design.htmlWhen...