Hello,
I am planning to drive 3 Stepper motors using ST drivers. Currently, I would like to use L6470 for 2 motors and L6480 for the remaining one.
I am planning to develop a test setup using following EVAL boards from ST,
X-NUCLEO-IHM02A1 - Drive 2 stepper motors
EVAL6480H - Drive 1 stepper motor
STM32 Nucleo Board - TBD
Can I use a single Nucleo board and daisy chain the SPI controls for both the motor boards? Can you suggest a Nucleo board for this configuration?
Thanks.
