Posted on May 17, 2011 at 09:49 /*
I have written an application that sits in bank 0, and have a bios sector in bank 1. I have not been able to get a function I've written to work that, I hope, will allow me to switch banks and run my bios routine in bank 1.
I can see from the Segger J-Flash utility, that my program is indeed there in bank 1, but I can't switch to it. Sending a ''0'' to this function resets the processor, and sending a ''1'' makes the processor hang, and only gets out of being hung by power cycling the board.
I am close to having a firmware download routine working, but am unable to get this part working. There is something simple I must be missing..Any help would be greatly appreciated.
Here is my routine:
My application starts at address 0x0, and the bios sector starts at 0x80000. I'm using the IAR4.41A compiler, and am using the STR912FAW44 version of the chip.
*/
typedef void (*pfunc)(void);
__ramfunc void bankSwitch(char bankNo)
{
pfunc jump2App;
if(bankNo){
FMI_BankRemapConfig(4,2,0,0x80000);
}else{
FMI_BankRemapConfig(0,6,0x80000,0);
}
jump2App = (pfunc)0x0;
jump2App();
}
[ This message was edited by: jmullens on 12-02-2008 03:35 ]
