LPS25HBTR_Recommended Land pattern
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-03-11 01:45 AM
Hi Team,
In our design we planned to use this part LPS25HBTR (Pressure sensor). As per Datasheet Recommended land pattern is not available.
Could you please share PCB land pattern for this part LPS25HBTR.
Thanks & Regards,
Karthikeyan
- Labels:
-
Accelerometers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-03-12 05:41 AM
Hi @Karthikeyan080692 ,
Welcome to ST Community!
The SMD rules for all MEMS devices are highlighted in TN0018. In ST website if LPS25HB is selected there is the section CAD Resources and is possible to download the footprint of device for different CAD.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-03-19 01:59 AM
Hi Federica Bossi,
You have shared land pattern is not Matching with actual part(LPS25HBTR).
Kindly please share corresponding part recommended land pattern of the footprint.
Thanks & Regards,
Karthikeyan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-03-19 08:46 AM
Hi @Karthikeyan080692 ,
TN0018 provides general guidelines for soldering MEMS sensor products, we don't have a specific technical note for LPS25HBTR. But the indications in that manual apply to all STmems, thus also to LPS25HBTR: