FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

I have a STEVAL-MKI185V1 magnetometer and I am logging data using the Unico software. When I access the log as a .txt file, I cannot seem to print the timestamp for each row of data. Does anybody know if this can be done? Thanks, Joe

JJame.16
Associate

‎2019-09-12 04:52 AM

 
0 Kudos
1 REPLY 1
Eleon BORLINI
ST Employee

‎2019-09-17 01:32 AM

Hi @JJame.16​ , the timestamp is not directly available through UNICO GUI, but you can go back to the time value starting from the ODR you set for the data output --> 1/ODR will be the basic time base. You can set the T0 according to your need. Regards

0 Kudos
Top