FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

I am using spc58NG DISP and I flashed my code for the first time using UDE4.8 debugger and it worked successfully, then i changed something in my code and wanted to flash it again but i always get this error from the debugger

MAbde.3
Associate

‎2020-05-26 04:26 AM

Message from component 'PpcJtagTargIntf' :

Can't connect target !

Message from component 'PpcJtagTargIntf' :

Failed to connect probably because of wrong processor state !

Please check:

- JTAG cable and Target Power

- Target's boot configuration

- Target's PLL configuration

- Censorship password configuration !

Message from component 'PpcJtagTargIntf' :

Processor is in UNKNOWN state !

Message from component 'PpcJtagTargIntf' :

Failed to halt processor !

Message from component 'UDEDebugServer' :

Unable to establish connection . To correct the situation, check configuration file entries and try again.

0 Kudos
This discussion has been locked for participation. If you have a question, please start a new topic in order to ask your question
0 REPLIES 0
Top