Posted on January 22, 2014 at 03:08hello Florian,
for this purpose, you need to implement pre mixer by mix coefficients setting .
for example , when channel 1 had been used for integrated speaker , and when external speaker is absent, you need to set mix coefficients of channel 1 to CH1=400000 , CH2=400000, mix coefficients of channel 2 to CH1=000000, CH2=000000. due to 7FFFFF is equal to 1 , so 400000 is equal to 0.5 in STA350BW DSP.
Thanks and best regards
Yun Tao ZHAO
From: breu.florian.001
Posted: Tuesday, January 21, 2014 12:32 PM
Subject: STA350BW: 2ch downmix to 1ch (Mono) with OCFG ''00''
Hello,
Planed: 1 integrated Speaker, 1 external Speaker.
If external Speaker is not connected, the internal one should play ''Mono''.
The configuration will remain ''2-channel (full-bridge) power, 2-channel data-out'' OCFG ''00''
In AP-Workbench and Datasheet, i did not found any Switch to generate ''Mono'' from 2-channel Input, with STA350BW.
Would this be possible using the PEQ? Post-Mix?
Are there additional Documents?
How can i configure this: (CH1+CH)/2 ?
Thank you best regards,
Florian Breu
