H3LIS200DL interrupt threshold meaning Hi, all.I am trying to figure out H3LIS200DL interrupt issue. Even if I have set interrupt threshold to high value, I can't see any pulse on INTx line. Also not sure what the INT1_THS register describes. Datasheet shows only 7 bit value.What I have done is as following./* initialized */
...
if (h3lis200dl_device_id_get(h3lis200dl->ctx, &whoamI) != HAL_OK) {
sprintf(pBuf, "Failed to get chip id\r\n");
tx_com((uint8_t*)pBuf, strlen(pBuf));
}
sprintf(pBuf, "Chip ID: %x \r\n", whoamI);
tx_com((uint8_t*)pBuf, strlen(pBuf));
if (whoamI != H3LIS200DL_ID) {
sprintf(pBuf, "Couldn't get valid chip id\r\n");
tx_com((uint8_t*)pBuf, strlen(pBuf));
while (1) {
/* manage here device not found */
}
}
/* Configure filtering chain */
/* Accelerometer - High Pass / Slope path */
h3lis200dl_hp_path_set(h3lis200dl->ctx, H3LIS200DL_HP_DISABLE);
h3lis200dl_pin_polarity_set(h3lis200dl->c
