I'm using the TSM8S001J3 for a small application that requires Pin-8 (PD1/ SWIM, PD5/ AIN5/ UART1_TX) to be used for the RS232-TX. Currently in the code I have a way to halt the GPIO assignment prior to reassigning the SWIM pin if needed by holding t...

Posted on March 09, 2018 at 16:27Has anyone replaced the shunt resistors with a isolated hall-effect current sensor?We need isolation for safety, but there is concern of introducing phase lag in the current signals.#iso-shunt-current #isolated-curre...

Posted on March 09, 2018 at 16:21We are working on a motor controller and started with a evaluation board that uses the STM32F031. Unfortunately we have utilized over 80% of the flash and 90% of the RAM, so going forward with the STM32F031 is a bit ...

Posted on March 05, 2018 at 05:29In Section 3.5.1 of the STM32F031 datasheet states:�The VDDA voltage level must be always greater or equal to the VDD voltage level and must be established first.�The statement �VDD voltage level and must be establis...